FOR-A FVW-700, Operation Manual

Page: 13 / 41

13
3. Connection
3-1. Using a Touch Panel Monitor
The figure below illustrates a connection example.
A
C
1
0
0
-2
4
0
V
5
0
/6
0
H
z
I
N
FVW-700 USB3 USB4 LAN1 LAN2 DVI-I
SERIAL ALARM
DISPLAY PORT
1 2 3 4
SDI OUT
GENLOCK
SDI IN
1 2 3 4
Do not connect or disconnect cables while the power is on. Doing so may damage the internal
circuitry.
3-1-1. Touch Panel Driver Installation
To use a touch panel screen, some monitors may require the installation of a touch panel
driver. For the FVW-700, C: drive is write-protected. (Write protection needs to be disabled
before driver installation.) Follow the steps below to disable the write protection, install the
driver, and re-enable the write protection.
1.
Click the
×
button in the upper right corner of the window to exit Video Writer .
2. Double-click the uwf_disable.bat in D:\forawork to execute the batch file.
3. Command Prompt opens and shows the following messages. Press any key once on
the keyboard.
**********************************************************************
The write-protection(UWF) for the boot drive(C:) is set to enable.
The any driver cannot install when write-protection is enabled.
**********************************************************************
Press any key to continue . . .
Copyright (c) Microsoft Corporation. All rights reserved.
統合書き込みフィルターはシステム再起動後に有効になります。
DisplayPort-DVI
conversion connector
(Supplied)
75
Ω
Termination
DVI-I Cable
LINE VIDEO IN
(HD-SDI)
GENLOCK IN
KEY
VIDEO
KEY
VIDEO
HD-SDI
HD-SDI
HD-SDI
HD-SDI
AC Power
Supply
RS-232C Cable / USB Cable
Touch Panel Monitor