21
4-2-6. Selecting 2-Channel Frame Synchronizers (FA-9520)
After establishing a connection with an FA-9520, press the MU SELECT button next to the
power switch to open the FS SELECT menu as shown below.
NOTE
See section 5.
“Establishing Connection with the FA-9500/FA-9520” for details on the
connection procedure.
F S S E L E C T
8 0 0
M O D E : F S 1
L I N K : D I S A B L E
Parameter
Default
Setting range
Description
MODE
FS1
FS1
FS2
Allows you to select which FS1 or FS2 settings to
change for FS1/FS2-selectable menus.
* FS1/FS2-selectable menus are shown in
section 4-2-2.
“Menu Buttons” in the FA-9520
(FA-9520 Mode) Operation Manual.
The selected FS1 or FS2 will be displayed in
place of the menu page for 3 seconds after an
FS1/FS2 selection change.
LINK
DISABLE
DISABLE
ENABLE
DISABLE: Allows you to separately change FS1
and FS2 settings.
ENABLE: Allows you to simultaneously change
the same amount of setting values for FS1 and
FS2 by turning the control knob.
NOTE
Pressing the MU SELECT button while opening the FS SELECT menu allows you to
return to the previous menu before the FS SELECT menu was opened.
If either FS1 or FS2 operation is locked, MODE and LINK settings are disabled, and the
menu display appears as shown below. See section 4-2-7.
” for details.
F S S E L E C T
8 0 0
M O D E : U N A D J U S T A B L E
F S 2 C H O S E N
F S 1 : L O C K
F S 2 : U N L O C K
IMPORTANT
When LINK is set to ENABLE in the FA-95RU, the connected FA-9520 will also be in
LINK mode, and FA-95RU units that are connected to the FA-9520 will also be in LINK
mode.
LINK cannot be set to ENABLE under the following conditions:
1. Either FS1 or FS2 is set to LOCK.
(See section 4-2-7.
“Operation Lock Function (FA-9520)” for details.)
2. Either FS1 or FS2 Color Corrector mode is set to Sepia.
(See section 5-2-4.
“COLOR CORRECT (C.C.) in the FA-9520 Operaion Manual for
details.)
3. AVO mode is not OFF.
(See section 5-4-1. AVO SETTING
” in the FA-9520 Operation Manual for details.)
