FONESTAR MX-865, Instruction Manual

Page: 6 / 12

EN
- 6 -
15.- PHANTOM : switches which let you activate or deactivate the phantom power supply for inputs MIC 1-
3 independently. The mixer supplies 15 V DC in the XLR terminals corresponding to the activated input.
16.- MIC 2 : microphone input with combo connector (XLR and 6.3 mm stereo jack). Balanced and
unbalanced microphone signals and dynamic or condenser microphones can be connected. If phantom
power supply is needed, the mixer itself supplies 15 V DC through the XLR connector activating the
phantom selector corresponding to the MIC 2 input.
17.- PRIORITY MIC : selector which lets you choose the attenuation that the mixer inputs are going to suffer
when priority is activated in inputs MIC 1-3. It is possible to select from 3 positions: off, -30 dB
attenuation, and total input attenuation.
18.- SENSITIVITY : control wheel which determines the necessary input sensitivity to activate priority in
inputs MIC 1-3.
19.- DELAY TIME : control wheel which determines the time the signal from the other inputs takes to return
to its normal volume, after one stops speaking through inputs MIC 1-3.
INSTALLATION AND CONNECTION
Maintain the mixer switched off while the connections are being made.
Check that the cable connectors are firmly connected to the input connectors. A bad connection could cause
noise or interference.
Use suitable cables and ones that are not excessively long to make the connections: shielded cables,
preferably low capacity.
Always start with the mixer volume controls at a minimum. Move the controls slowly.
Connect the source to the mains (230 V AC).
When not using the mixer disconnect the power supply source from the mains to avoid using electricity.
CONNECTION DIAGRAM
MX-8651_MANUAL_(EN)_20170605_Maquetación 1 5/6/17 12:30 Página 6