Service Manual
båÖäáëÜ
cê~å´~áë
79
5. Attach the handle sleeve to the camera.
NOTICE! Make sure that the sealing ring (A) is properly seated.
6. Unscrew the ring nut.
NOTICE! Tighten the ring nut only by hand.
4.20
Replacing the handle sleeve of the camera
➢ To replace the handle sleeve, the cable must be removed from the
cable.
This is described in the section titled Replacing the camera cable
Summary of Contents for MyCrown Design
