40
MyCrown Design
4.7
Replacing the display
Removing the back panel
✔
The unit is switched off and the power cable is disconnected.
1. Remove the 6 screws from the back panel.
2. Pull off the back panel parallel to the back. NOTICE! Observe the
ground cable and button connection.
3. Carefully pull away the ground cable on the device side and
disconnect the link to the button connection.
4. Put aside the rear panel.
Removing the display
1. Remove the screws.
2. Tilt the display forward.
NOTE: Make sure that the display does not fall down.
3. Remove the DVI cable and the power supply cable from the display.
Summary of Contents for MyCrown Design
