32
MyCrown Design
2. Fasten the controller securely with 4 countersunk screws. To do so,
the controller must be raised slightly.
4.4.2.3
Connecting the cables
Fastening the protective ground wires
➢ Fasten the 2 protective ground wires at position (A).
Please note the order:
screw > washer > protective ground wire > protective ground wire >
contact wheel
The claw fasteners of the contact wheel must be pointed towards the
sheet metal wall (upwards in the illustration).
NOTICE! Do not allow any small parts to fall into the column.
Summary of Contents for MyCrown Design
