26
MyCrown Design
4.4
Attaching/removing the controller
4.4.1
Dismantling the controller
4.4.1.1
Disconnecting the cables
Preparation
✔
The unit is switched off and the power cable is disconnected.
1. Remove the camera cable.
2. Remove the back cover. The cover can remain hanging on the
device.
NOTICE! Do not subject the cables to any tension.
NOTICE
Backup data
Before the old controller is removed, the user has to save personal data
to suitable media. For data protection reasons, these data must then be
removed from the old controller.
Summary of Contents for MyCrown Design
