WWW.FOMEI.COM
Ba
sic Hobb
y L
ED
You should first mount the LED light onto a light stand. At the base of the light you will see
an integrated tilting bracket. Loosen the large knob on the side of the tilting bracket and
orient the lower portion of the bracket down and away from the light. Tighten the large
knob. This position will place the 5/8” hole in the bottom of the bracket facing a downward
position relative to the light head and prepare it for mounting to a light stand.
Now loosen the smaller knob on the tilting bracket. This is a setscrew on the side of the
tilting bracket, which is used to hold the light firmly onto a light stand. You should loosen
it enough so the set crew is not protruding into the 5/8” hole. Slide the entire light onto a
standard light stand. Now tighten the setscrew to firmly hold the LED light onto the light
stand.
Connect the AC cord to the AC/DC transformer by pushing the ‘figure-8’ style end of the
cord into the transformer. Next, push the small, round, DC connector from the AC/DC
transformer into the DC port on the back of the LED light. Finally, connect the household
end of the AC cord to a common wall outlet to provide power to the unit.
Use the round dial on the back of the light to turn the light on or off and adjust its power
(light output) setting.
OPERATING THE LED LIGHT
The round dialon the back of the lightallows you to adjust the brightness of the light from
approximately 5% to a full 100% output. Rotate the dial from its minimum setting to its
maximum setting and back to see the effect. Your light includes a white diffusion sock.
This sock can be stretchedover the front of the light to soften its light output.
Another option is to slide a photographic umbrella (sold separately) into the umbrella shaft
port located in the light’s tilting bracket for additional light shaping opportunities
C. PRODUCT USAGE
