Foma D704i, Manual

Page: 48 / 498

46 Voice/Videophone Calls
[Videophone call]
●
If a videophone call is not connected, one of the following messages appears on the screen and then the standby
display reappears. Note that the displayed message may not reflect the status of the other party’s terminal correctly,
depending on the type of the terminal or the network service used by the other party.
*1 The message may also appear when the other party is in packet communication, depending on his or her terminal.
●
If a videophone call failed to be connected while
Auto redial as voice
is set to
ON
, the call is automatically redialed as a
voice call. If redialing as voice call occurs, voice call charges apply.
●
When there is an incoming call while dialing a videophone call or redialing, the dialing may be interrupted and the ring
alert may sound.
●
Even if sending/receiving sound or image is aborted and (sound only) or (image only) appears during
a videophone call, the call may be continued.
●
Please note that digital communication charges apply to videophone calls instead of voice call charges even if the
substitute image or Chara-den is used.
Putting calls on hold while talking
On-hold
Putting the call on hold while talking makes your voice unheard to the other party. Callers are charged for the
time spent on hold.
1
o
during a call
･
To resume a voice call on hold, press
o
or
n
.
･
To resume a videophone call on hold, press
o
. The image that has been sent before the hold
reappears.
Message Description
Busy.
The other party is busy.*
1
Redial using voice call
. This message appears when the other party has activated Call Forwarding Service
with the forwarding destination set to a terminal incompatible with videophone.
Upper limit exceeded
.
Connection
failed
.
This message appears when the limit is exceeded for a billing plan with a charge
limit (such as Type limit and Family Wide limit).
Connection failed.
Set Caller ID Notification to
Notify
and dial again.
･
The message may also appear in cases other than the above.
Out of service area/power off
. The other party is outside the service area or the other party’s terminal is turned off.
Busy with packet transmission
. The other party is in packet communication.
Set Caller ID to ON.
This message appears in case of connecting without notifying the caller ID (when
accessing to V-live or visualnet).
Check number, then redial
. You dialed the phone number not used.
Make call from i-mode web page.
This message appears when using V-live. Access to the IP site via i-mode then
make a videophone call on the site screen.
Voice call on hold Videophone call
on hold
On-hold image
Flashes
The call is put on hold and a guidance (on-hold
tone) is heard. For videophone calls, the on-
hold image appears on the other party’s
terminal.