Foma D704i, Manual

Page: 318 / 498

316 Data Display/Edit/Management
Point the infrared data port of the FOMA terminal at
the infrared receiver of the equipment and perform
remote control operation (operation differs depending
on i-
α
ppli). Effective angle for remote control is 15
degrees from the center and the distance is about 4
m at the maximum. However, the angle and distance
effective for the operation differs depending on the
type of devices to operate and the level of ambient
brightness.
Setting operations for data transfer
Data Exchange Setting
Set operations for data transfer by infrared
communication, iC communication and USB
connection.
1
m635 z
Set each item
z
p
iC communication function
iC Communication
Data is exchanged between the FOMA terminals
equipped with the iC communication function by
overlapping the FeliCa marks ( ) of both
terminals.
･
The type of data that can be sent or received is
the same as with infrared communication.
☛
P312, P313
･
Data prohibited from being output from the FOMA
terminal cannot be sent/received. However, this
excludes the data whose file restriction is set to
File restricted
with your FOMA terminal and the
data in the
Data transfer
folder.
･
During iC communication or saving received data,
is displayed at the top of the screen and the
terminal is in the data transfer mode (the same
status as outside the service area). In this mode,
phone calls, i-mode connection and data
communication are disabled. Also you cannot
switch to other functions by pressing
b
. Also,
you cannot use iC communication during a call,
i-mode or data communication because you
cannot use the data transfer mode.
･
Depending on the other party’s FOMA terminal, it
may be difficult to send or receive data. Try
adjusting the distance between the FeliCa marks
or moving either terminal slightly up, down, right
or left.
Using iC communication to send data
You can send data by selecting one item at a time
or send all data items for a specified function in a
batch.
Remote control operation
Default End alert: OFF Auto authentication: OFF
Ph. book image sending: ON
End alert
：
Set whether to sound a beep at the end of
communication.
Auto authentication
：
Set whether to automatically exchange
authentication codes with the other party
during USB connection to use DoCoMo
keitai datalink. If you set
ON
, it eliminates
the need to enter the authentication
password every time.
･
To set
ON
, enter the terminal security code
and the 4 to 8-digit authentication codes
for the mobile phone terminal (the FOMA
terminal) and for PC (the other party), and
then press
p
.
Ph. book image sending
：
Set whether to send images saved in the
phonebook when you send all items of the
phonebook data in a batch.
Infrared receiver
Infrared data port
Approx. 4 m
15 ° 15 °
Overlap the FeliCa
marks so that the
distance between them
is 1 cm or less. Also take
care not to move them
while data is being
exchanged.
･
When you overlap
FeliCa marks, be
careful not to give
shocks to the FOMA
terminals.