Foma D704i, Manual

Page: 260 / 498

258 Watching TV
1Seg may be automatically activated upon
completion of a call. You may be surprised by a
sudden sound of 1Seg while you are still holding your
FOMA terminal close to your ear.
INFORMATION
● You cannot view 1Seg if UIM is not inserted, subscription
to DoCoMo is canceled or use of the FOMA service is
stopped.
●
Even if the subscribed UIM is inserted, repeating 1Seg
activation while the communication is unavailable
because of outside of the FOMA service area or any
other reason disables further activation of 1Seg. In that
case, move back to within the FOMA service area to
enable activation of 1Seg.
●
When you view 1Seg for the first time, activate 1Seg
within the FOMA service area.
●
If the saved data should be lost or corrupted due to
failure, repair or other handlings of the FOMA terminal,
DoCoMo assumes no responsibility for the loss of data.
When you have your FOMA terminal repaired or
purchase a new one, the data you saved in your FOMA
terminal (such as videos or still images recorded from
1Seg, TV links and the information saved in the
broadcast storage area) cannot be transferred. It is
recommended that you keep a record of such information
separately.
Setting channels
Channel Setting
Before watching 1Seg TV, it is necessary to set
channels and register channel lists.
･
Up to 10 channel lists can be registered. If you
register channel lists according to local service
areas, you can view TV channels of a local area
just by selecting the corresponding channel list.
･
To a single channel list, up to 62 channels can be
registered.
Registering channel lists
Two setting methods are available: one is to select
an area to set from the area list registered in the
FOMA terminal (
Select area
) and the other is to detect
automatically the channels available in your current
location from broadcasting signals (
Auto channel set
).
1
m95
2 Select an area or perform automatic
channel setting
■
Selecting an area:
Select area
z
Select a
large area
z
Select a detail area
･
To confirm the available channels of the
detail area: Highlight an area in the detail
area list
z p
･
Press
o
to select the highlighted area.
■
Performing automatic channel setting:
･
It takes about 10 to 60 seconds to complete
the automatic channel setting.
a Auto channel set
The automatic channel setting starts and a
confirmation screen appears upon
completion of automatic setting.
b Yes
･
If multiple broadcasting areas are
available, channel numbers (remote
control numbers) may overlap between
areas. When a message appears, press
o
and select an area.
3 Enter a channel list name (up to 20 one-
byte or 10 two-byte characters)
z p
･
The detail area name is already entered as the
channel list name when selecting an area, and
the date and time of setting is entered when
performing the automatic channel setting.
1
m95
The channel lists are displayed.
2 Highlight
[Not recorded]
z t
(
Area
) or
a
(
Auto set
)
･
The following procedures are the same as for
registering the first channel list.
･
When a channel list is added, a confirmation
screen appears asking whether to set it as a
channel list to use. Select
Yes
or
No
.
INFORMATION
●
When you select an area, channels may not be set
properly depending on the area. In this case, use the
automatic channel setting.
Registering the first channel list
Registering additional channel lists