8
25/50 Series 220 V 60 Hz/230 V 50 Hz Dispensers
11. Turn on water supply and check that water level in fl oat reservoir (when full) is within 7mm (1/4") of mark on side of
reservoir, and that fl oat moves freely. Check for leaks.
12 Verify that water sensor tabs are immersed in water in reservoir.
13. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull forward.
14. If dispenser is equipped with SensorSAFE, remove protective plastic coating from dispense sensor labels.
15. Turn on dispenser power and bin signal rocker switches. Check dispenser and ice machine operation.
16. Sanitize ice machine according to instructions in ice machine manual. Discard sanitized ice.
17. Turn off ice machine bin signal switch.
18. Remove dispenser hopper lid; clean and sanitize dispenser according to instructions beginning on page 16.
19. Turn ice machine bin signal switch on and replace front covers, securing with screws.
800mm
384mm
79mm
79mm
259mm
267mm
171mm
20mm
(19mm) 3/4" FPT drain (B)
power cord
19mm (3/4") MPT icemaker drain location (B)
(air-cooled only)
access panel
(A) 10mm (3/8")
push-in water
inlet
(31.5")
(3.125")
(3.125")
(10.25")
(15.125")
(6.75")
(10.5")
(.8")
10mm (3/8") FPT condenser inlet location (D)
(water-cooled only)
10mm (3/8") FPT condenser outlet location (E)
(water-cooled only)
19mm (3/4") MPT icemaker drain location (C)
(water-cooled only)
Fig. 1 – Rear connections, freestanding models
