Service
Door Gasket Replacement
1. Remove existing gasket from mounting track.
2. Verify mounting track is free of any remaining gasket material.
3. Align new gasket with mounting track and press firmly in place.
4. Open and close door, checking for proper gasket seal without
pinching against refrigerator.
5. Adjust latch and or striker as necessary for proper door closure.
Slide-out Compressor Tray
Follett’s slide-out compressor tray allows technicians to partially slide the
condensing unit from the freezer back without cutting refrigerant lines.
1. Remove rear panel (Fig. 14.1).
2. Remove two bolts securing condensing unit to unit base
(Fig. 14.2).
3. Carefully slide out condensing unit (Fig. 14.3).
Note: Do not put strain on the refrigerant lines.
Fig. 14
0104175510
2
1
3
Removing Drawers
1. Pull drawer forward to stop (Fig. 15.1).
2. Lift drawer front to free front rollers from sides (Fig. 15.2).
3. Still lifted, pull drawer forward to free back rollers from sides
(Fig. 15.3).
Fig. 15
2
1
3
Removing Slides
1. Push slides all the way back.
2. Swing bottom of slide away from refrigerator wall and lift slide off
of rollers.
REF4P and REF5P Undercounter Refrigerators 13
REUC235
