Installation
Before beginning installation
Follett’s REF/FZR stacking kit may be used ONLY with REFs or FZRs
equipped with a STRAIGHT bottom kickplate
(Fig. 1).
If your REFs or FZRs have recessed kickplates
(Fig. 2), replace them
with the straight kickplates included with this kit.
Note on instructions:
TOP and BOTTOM refer to final stacked configuration
Installing levelers
1. Remove levelers from plastic bag packed inside unit.
2. Tip refrigerator back and screw levelers (Fig. 3) in all the
way to stop (they will extend 1/8" below base).
3. Adjust levelers as needed to level unit in both directions.
To access levelers, remove the lower front panel. Turn
levelers clockwise to extend levelers.
Fig. 1 – Straight kickplate
recessed area
recessed area
Fig. 2 – Recessed kickplate
Fig. 3
CAUTION
• DO NOT TRANSPORT STACKED UNITS. Transporting stacked units can result in damage to units.
• DO NOT USE CASTERS ON STACKED UNITS. Attempting to use casters on stacked units could result in
personal injury or damage to the unit.
Electrical requirements
• Each unit requires a separate 15A circuit
Tools required
• #2 Phillips screwdriver
• 1/2" Wrench and 1/2" socket
Materials supplied
(16) 10-32 x1/2 pan-head screw (00902213)
(1)
Right side stacking bracket (01041011)
(1)
Left side stacking bracket (01041029)
(4)
Bracket,unit (00988428)
(4)
Bracket, wall (00988436)
(4)
5/16 Bolt (207476)
(4)
5/16 Nut (200457)
(8)
Flat washer (207005)
(4)
5/16 Lock washers (207475)
(8)
Extra kick plate screws (203460)
(2)
Straight kick plates (01067016)
Order parts online:
www.follettice.com
01054022R03
801 Church Lane • Easton, PA 18040, USA
Toll free (877) 612-5086 • +1 (610) 252-7301
www.follettice.com
Installation Instructions
Performance Plus atop Performance Plus
Undercounter Refrigerator/Freezer Stacking Kit
P/N 01054006
