Foerster TAK5-CH1-25, Instruction Manual

Page: 82 / 226

82 Device data
water portion after an adjustable time. The stainless steel coil is
then filled with water, thus preventing the milk from thickening in
the coil.
1. > device data > milk values
2. Enter the desired value in drain .
When an animal with feed entitlement enters the feeding station,
the water portion in the heat exchanger is dispensed into the
mixer jar and drained via the mixer draining valve. Only then the
milk is dispensed into the mixer jar.
5.7.5 Commuting to the single heating circuit
As a rule the water is heated in the boiler of the heat exchanger
and the milk in the stainless steel coil. If the milk ratio of animal’s
feed portion is too low, the automatic feeder automatically com-
mutes to the 1-circle mode . That means that the water as well
as the milk are heated in the stainless steel coil of the heat
exchanger, thus preventing the milk from staying too long in the
coil.
Default value: 1 hour
Allowed range: 0 to 3 hours
Note: To avoid that the milk stays too long in the stain-
less steel coil of the heat exchanger, the default value
should remain unchanged.
milk values
...
dry matter: 135 g/L
drain: [1 h]
1-circle: < 30 %
Note: If you select 0, draining is deactivated.
The idle time begins after the last milk portion has been
dispensed.