Foerster TAK5-CH1-25, Instruction Manual

Page: 49 / 226

Start-up 49
Recommendations for temperature settings
The automatic feeder and the heat exchanger are designed in
such a way that also milk powders with higher fat melting point
can be used without any problems. Make sure that the feed tem-
perature in the mixer jar is between 42 ºC and 43 ºC.
If you solely use whole milk or cold-soluble milk powders, a lower
temperature of the feed in the mixer jar may be sufficient (e. g.
38 ºC).
Set temperature Min. temperature
Default value: 41 ºC 38 ºC
Allowed range: 10 ºC to 44 ºC 0 ºC to set tempera-
ture minus 0.5 ºC
Note: The values entered for the target and the minimum
temperature are converted to the target and the minimum
temperature of the boiler water. If the temperature of the
boiler water falls below the minimum temperature, feed
preparation will be broken off until the minimum tempera-
ture is achieved again.
Note: If you want to deactivate the minimum temperature
parameter, in min. temp. enter 0 ºC .
Warning : Too low feed temperatures may cause digestive
troubles. Too high feed temperatures may lead to inflam-
mations of the mucosa in the abomasum.