Foerster TAK5-CH1-25, Instruction Manual, Page: 174 / 226

174 Failures and warnings
12.1.5 Water shortage
If the bar resp. the supply electrode is not grounded in the
mixer jar during water dispense and the water meter does not
transmit any pulses, the device will start a water check. If water
check fails, feed preparation and animal identification will be
switched off.
> Press in water bo. start? .
> Press in water HE start? .
> Check whether the water jet touches the bar electrode re-
sp. the supply electrode.
> Check the water supply to the automatic feeder.
> Press in delete failure? .
> Exclusively for electricity specialists : Check the sensitivity
of the electrode:
The sensitivity of the electrode is:
•
too high , if the electrode signals covered though it is actually
free.
•
too low , if the electrode signals water shortage though it is
covered.
Note : Check whether the stop valves and the drain-
ing valve are tight. If some liquid in the mixer is drained
via one of these valves, the bar electrode may not be
grounded anymore.
failure
water shortage
water shortage
water bo.: start?
water HE: start?
bar el.: start?
supply el.: free