Foerster TAK5-CH1-25, Instruction Manual

Page: 155 / 226

Diagnostic 155
10.4.2 Concentrate stations
Here you can
> check whether the identification of the concentrate station is
working properly,
> start the motor of the concentrate station,
> view whether the feed bowl is currently full or empty,
> view the control unit allocated to the concentrate station,
> check the animal scales allocated to the concentrate station,
> retransfer the CAN-bus-address to the concentrate station.
10.4.3 Animal scales
If an animal scales is allocated to the feeding or the concentrate
station, in diagnostic the menu scales will be displayed for this
station. Press in this line to access a submenu. Here you
can
> view the scales control allocated to the scales,
> carry out a test weighing,
> tare the scales,
> calibrate the scales.
10.5 Control
In control (see 12 Failures and warnings, page 171 ) you can
view how often:
•
the automatic feeder was without current ( power failures ),
•
the control of the automatic feeder fell back on internal back-
up after memory error occurred ( Reset ),
•
the connection to the terminal was faulty,
•
a database error occurred,
<C-station 1>
no. ‡: 945637
motor: start?
feed bowl: full
control: [IFS-C 1]
scales
search?
<F-station 1>
...
scales
search?
scales
alloc.: SC 1/2
weigh?
tare?
calibrate?
diagnostic
valves
motors
heating
sensors
stations
control
version
setup
software