Cleaning
31
4. For
Cleaning 1
, enter the desired time of day.
5. For
Cleaning 2
(option), enter if necessary the desired time of day.
Note:
Start the cleaning at a time when there is minimal entitlement to feed so that your calves
do not have to wait too long for feed.
Note:
If there is still feed in the mixer beaker at the set cleaning time, automatic cleaning will be
postponed by a maximum of one hour. After that, any remaining feed will be pumped out if nec-
essary via the mixer drain valve, and the cleaning cycle will be started.
6.3
Teat cleaning
After each visit of a calf to the feeding box, the tat is automatically cleaned with water from out-
side.
You set the teat cleaning as follows:
1. Choose
> Cleaning
in the
Settings
sub-menu.
2. Set for
teat cleaning
, how long the teat should be sprayed with water.
You can enter a value between 1 and 9. 0 means that teat cleaning is deactivated.
Note:
Depending on the desired cleaning effect, the water pressure can be reduced via the
pressure reducer.
6.4
Teat cleaning
After cleaning, a small amount of clean water is pressed out of the teat to clean the interior of
the teat.
You set the teat cleaning as follows:
1. Use
> Cleaning
to navigate to the
Settings
sub-menu.
2. Set
Teat cleaning
to
yes
.
6.5
Manually starting tube cleaning
You can also start the cleaning of the tubes manually.
To start the cleaning of the tubes manually, proceed as follows:
1. Choose
> Cleaning
in the
auto.
sub-menu.
Tube cleaning
.
2. In the
start flushing agent 1?
menu, press to perform an alkaline cleaning cycle, or in the
start flushing agent 2?
menu, press
to perform an acid cleaning cycle, if a second
cleaning agent pump is available.
2.1.
If necessary confirm
Exit automatic mode?
by pressing
.
2.2.
Enter the required amount of cleaning agent and confirm by pressing
.
Note:
Start the cleaning at a time when there is minimal entitlement to feed so that your calves
do not have to wait too long for feed.
