12
Stepper pump (Sample water pump)
Pump A (RO water pump)
1) Open the Mastertronic app, and enter calibrate,
and choose ‘
Stepper'
or
‘Pump A'
2) Press ”
Ready
”. Now machine will perform a
procedure and
just wait until the machine
completely has stopped
.
3) Now carefully check the feeding hoses (see pic)
to the chamber are fully primed. It should be, but
during certain circumstances it may not be, and
in that case you have to repeat the step 4-6 below a few times.
If you repeat the
step 4-6 to get fully primed, do
not forget to have the collecting
measure cylinder totally empty
when you press ”start/redo” the
last time. Thus never use the
first output of water if it was not
fully primed. Only use the
volume after a redo and when
the hose is already fully primed
at the edge of the chambers.
4) Now press ”
Start/Redo
”. A popup window will now ask you to put the waste hose
into the included measuring cylinder. Then press ”
Calibrate
”.
A series of pump
actions will start and do NOT press any other buttons until all pumps have
stopped!
5) Water has now been delivered in the measuring cylinder
.
6) Read water amount in the cylinder. Enter in the app with
one decimal point (x.x), and press ”
Save
”.
7) Now its actually possible to redo the calibration if you
are uncertain it was done correctly, just press
”Start”Redo” and follow the instructions again from step 4.
8) Now when calibration is finished its advisable to press
”test pump accuracy” to confirm you have a perfectly
calibrated pump. If you do that it’s the same as above, just
collect the water that is coming out from the waste hose
and it should be 7.0 ml if the pumps are perfectly
calibrated.
9) When you are done, finish the session by press ”
Empty
Hose
”.
The app will not allow you to leave the page
before you press this for security reasons. But if the
app, for any unpredictable reason, doesn’t prompt you to ‘empty hose’,
always do that immediately through the maintenance page!
10) Don't forget to put waste hose back into the container where you collect the
waste water!
*
This extra button is normally not to be used. Read more in FAQ.
*
