Original User Guide | Pedelec Shimano Steps E8000 Version 1
US-23
3.3.1 Screw supports: Shifting and tilting the saddle
1. Loosen the clamping screw by
turning it anti-clockwise. Turn the
screw completely two to three times
at most or the whole mechanism
could fall apart.
2. Shift the saddle forwards or
backwards as desired.
3. Tilt the bike saddle to the desired angle.
4. Tighten the clamping screw by turning it clockwise with a torque
wrench.
5. Ensure that the newly-tightened saddle does not tip; test it by pressing
down on the front and back alternately.
3.3.2 Twin-screw supports: Shifting and tilting the saddle
WARNING
Screw the clamping screws fully in a straight position in the nuts.
Failure to do so can result in the screws tearing out of the nuts.
correct
Clamping screw
Fig. 1
wrong
Fig. 2
For 1. Loosen the clamping screw
1. To shift the saddle, loosen the
front and rear screws by turning
them anti-clockwise. Turn the
screws completely two to three
times at most or the whole
mechanism could fall apart.
2. Shift the saddle forwards or
backwards as desired.
3. Tighten the screws using a torque wrench to turn them clockwise.
4. To alter the angle of the saddle, loosen the front screw by turning it
anti-clockwise. Turn the screw completely two to three times at most or
the whole mechanism could fall apart.
5. Tighten the front screw with the same number of turns.
6. Ensure that the newly-tightened saddle does not tip; test it by pressing
down on the front and back alternately.
3.3.3 Clamp attachment: Shifting and tilting the saddle
1. Turn the clamping nut clockwise
to loosen it. You may need to
keep the nut on the other side in
place with a second key.
2. Shift the saddle forwards or
backwards as desired.
3. Tilt the bike saddle to the desired angle.
For 1. Loosen screws
For 1. Loosen clamping nut