REMOVING CIRCUIT BOARD
38
Fluid Management
®
REMOVING
CIRCUIT
BOARD
Read all of the following instructions. If you have any doubt about
performing these procedures, please contact Customer Service at Fluid
Management.
Turn to the Parts Section for component identification and location.
1. Unplug the electrical cord.
2. Remove the sheet metal screws on the control panel and slowly swing it
down.
3. Remove the top cover.
4. Remove the push-on type connector at the bottom of the printed circuit
board. Pull the connector with alternating left and right force away from
the circuit board. It is not necessary to loosen the screws on the connec-
tor.
5. Remove the four (4) screws and hold nuts that attach the circuit board to
the control panel.
6. Install the new board with the push-on connector.
7. Reinstall the control panel and the top cover.
8. Connect the electrical cord.
The mixer must be unplugged before
attempting this procedure. There is a
chance of electrical shock.
WARNING: ELECTRICAL HAZARD
