OPENING MIXER
30
Fluid Management
®
OPENING
MIXER
REMOVE THE EXTERIOR PANELS
1. Using a medium-size screwdriver or 1/4" nut driver, remove the sheet
metal screws securing the top cover. Lift it off the mixer.
Figure 6 Removing the Mixer Coverings
2. In the same manner, take off the upper rear cabinet (3-sided piece) cov-
ering the sides and back, and set to the side of the work area.
3. If your machine has a 4-sided skirt, remove it now.
4. At the back of the mixer, squeeze the power supply strain relief with a
pair of pliers, and pull it off the cord. Move the back panel away from
the machine (the cord will still be attached).
5. Remove the right and left side panels, and the lower front panel.
6. To prevent damage, remove the mixer door by lifting the door off its
pins.
7.
Cut the upper wire tie wrap securing the three (3) cables to the outer
frame at the left side of the machine.
8.
Remove the remaining front sheet metal covering. Carefully prop the
front piece (two front columns with control box assembly) to the side
of the machine, being careful to not damage the cords.
CONTROL
FRONT
FRONT
FRONT
LOWER REAR
SHEET METAL
UPPER REAR
BOX
ASSEMBLY
DOOR
COVER
(STAINLESS STEEL)
PANEL
SCREW
CABINET
RIGHT / LEFT
SIDE PANEL
TOP
COVER
PANEL
(NOT SHOWN)
