REPLACEMENT PARTS LIST
To order replacement parts for your Playmate, use the order
numbers in the list below. Replacement parts are available only as
listed. Replacement parts are not available from Product Support,
but can be purchased from hobby shops or mail order/Internet
order fi rms. If you need assistance locating a dealer to purchase
parts, contact:
Product Support
Phone: 217-398-0007
Fax: 217-398-7721
E-mail: [email protected]
Stock #
Description
HCAA6300 Wing
HCAA6301 Tail
Set
HCAA6302 Fuse
Set
HCAA6303 Landing
Gear
HCAA6304
Pushrods and Control Horns
HCAA6305
Propeller with Spinner
HCAA6306
Motor with Gearbox
HCAA6307 Motor
HCAA6308 Gearbox
HCAA6309
130 mAh LiPo Battery
HCAL7600 2.4GHz
Tx
HCAL7601
Micro Control Unit (Rx/ESC/Servos)
PROBLEM
CAUSE/SOLUTION
For any other problems not addressed here, please contact Product Support.
The power LED on the
transmitter does not
illuminate when the switch
is moved to the ON position.
The AA batteries in the transmitter are exhausted. Replace with new AA batteries.
The AA batteries in the transmitter are installed incorrectly. Reinstall the batteries
correctly as described on page 3.
The LEDs on the transmitter
are dim or the transmitter
emits a long beep.
The AA batteries in the transmitter are low. Replace with new AA batteries.
The control surfaces do not
move in the correct direction.
The transmitter control functions need to be reversed. Follow the reversing
procedure described on page 5.
The plane control surfaces
or throttle do not respond
to control stick inputs from
the transmitter.
The LiPo battery is depleted. Charge the battery.
The LiPo battery is not properly connected to the airplane. Disconnect the battery
and reconnect it, ensuring it is fully engaged in the connector in the
correct orientation.
The transmitter has become “unbound” with the airplane (the transmitter and
airplane can no longer communicate with each other). To rebind the transmitter
to the airplane, turn the transmitter switch to the ON position. Connect the LiPo
battery to the airplane. While pressing the UP TRIM button next to the left
control stick, press the DOWN TRIM button next to the left control stick.
The transmitter will make several quick beeps, indicating the binding procedure
is complete. Confirm operation of the airplane with the transmitter.
TROUBLESHOOTING
