EN
GL
ISH
12
Ex
TE
ND
T
hE
B
-S
AF
E L
IN
E
Tip:
Go beneath the A-Level and lift it above your head. Put it
on the shoulder which points toward the middle of the PEAK5.
The lines of the B-Safe System run through the rings inte-
grated into the B-Level ribs. Search for the red LCL (Little Con-
nection Line) and connect the B-Safe Top Line with a Lark‘s Head
knot.
Check if the B-Safe Top Line is correctly attached and runs
free beneath the A-Level. Repeat the process on the other side
of the PEAK5.
09 ExTEND ThE B-SAFE LINE
Open both lark‘s head knots.
Loosen the connection and push the loops over the knots.
Pull the B-Safe Line taut.
10 CONvERT TO ThE FRONT
LINE SAFETy SySTEM
10.01 Convert the CONNECT2 Control Bar from the
5-line B-Safe System to a 4-line Front Line Safety
System
Take the cardboard winder out of the CONNECT2 bar bag and put
it aside.
Disconnect both B-Safe Top Lines (B-Safe Main) from the
PEAK.
Open the connection of the B-Safe Top Lines and the B-Safe
Line (5th line).
Attention:
thread all lines slowly to avoid damage caused by
friction!
Wind the B-Safe Top Lines around the cardboard winder.
Unwind your flying lines until you reach the Front Connection
Line. Thread the B-Safe Line through the metal ring of the Front
Connection Line.
Note:
In case the B-Safe Line has a knot at the end, open the
knot to easily thread the line through the metal ring.
Summary of Contents for CONNECT2
Page 1: ...USER MANUAL CONNECT2 EN...
