Website
26
Set the receiver as a PWM converter for PWM channel
expansion. After the setting is successful, the receiver is
used as a PWM converter, and its interfaces output PWM
signals.
Take FGr12B receiver as a Master receiver and FGr8B
receiver as a PWM converter as an example to explain how
to set the converter and the connections.
7.4.9 Config RX as a PWM Converter
1. E
enter
Set as PWM converter
menu
.
2. Click + / - to set t
he slave's
Start channel
and
Frequency
,
then click
Config
to start.
3. Put the receiver into binding state, when the receiver LED
turns fast flashing to two-falsh-one-off, it indicates that
the config is finished, tap to return.
1. The transmitter and the receiver FGr12B have bound.
2. Set the interface which is going to connect the PWM
converter to
i-BUS-OUT
.
3. Set FGr8B as a PWM converter, please note the start
channel number.
4. Connect the NPA interface of the PWM converter to the
interface set to
i-BUS-OUT
of the FGr12B receiver.
Function Settings:
Notes:
1. The receivers that can be set as a PWM converter are list here:
FGr8B, FTr8B, FGr12B, FTr12B, FGr4B, INr6-HS, FGr4 or FTr10.
2. The receiver set as the PWM converter can be converted into a
receiver by rebinding the transmitter, and then used normally
as a receiver after successfully rebinding the transmitter.
Notes:
1. For the classic receivers, after it is set as a PWM converter, its
SENS interface is connected to the interface of the receiver
outputting i-BUS signal.
2. For the enhanced receivers, after it is set as a PWM converter,
its NPA interface is connected to the interface of the receiver
outputting i-BUS signal.
Function Settings:
