FlySky Paladin PL18 EV, User Manual

Page: 15 / 61

Website
11
1. Check to make sure the receiver is installed correctly and that the receiver is powered off.
2. Press and hold both
Power Switch es until the screen lights up.
3. Power on the receiver.
5. Operation Guidelines
Follow these guidelines to set up the transmitter and the receiver.
5.1 Power On
Follow the steps below to power on:
ATTENTION • The system is now active, be cautious to not cause damage or personal injury.
5.2 Binding
The transmitter and the receiver have been pre-bound at the factory. If you need to rebind or bind a new receiver
follow the steps below. The Flysky AFHDS 3 receivers are consisted by classic version receivers and enhanced
version receivers. The bind method is slightly different between these two versions.
Note: Flysky AFHDS 3 classic version receiver models: FTr10/FGr4/FGr4s/FGr4p/FTr4/FTr16S. Other Flysky AFHDS 3 receivers
are enhanced version receivers.
WARNING
• Power off the servo while the transmitter and the receiver is binding. Otherwise it may
lead to danger.
• After the binding process is finished, power off the receiver, then power on the receiver
and check to make sure that the transmitter and the receiver have bound successfully.
Tap , then access Binding setting via RX setup .
The binding interface of classic receiver:
To set the transmitter and the receiver
to connect in one-way or two-way. If the
√ appears, indicating that the transmitter
and the receiver are connected in two-way.
Click Bind to put the transmitter into
binding mode. After that a menu will pop
up which is showing the binding process.
Note: When you choose one-way
communication, the receiver does not
send the data to the transimitter, the LED
flashes slowly after the receiver receives the
binding information. Then manually put the
transmitter to exit the bindig mode. When the
receiver LED is solid on, it indicates that the
binding is finished.
To bind with classic version
receivers. After clicking Bind,
a menu prompt of compatible
with the receivers will be
popped up.
Note: This function is available for version 1.0.28 or above.