Website
8
Function Settings:
By adjusting the tension screws on the back of the transmitter, gimbal stick can be either self-centering or non
self-centering, as well as changing stick tension preference
.
Available options:
CAUTION
• When the counterclockwise adjustment is made， the entire range of movement of the
screw is about 6 circles(the tightest to the loosest). Be cautious not to adjust it too far or
the screw will fall out.
Take the right gimbal as example:
Non Self-centering
to Self-centering
Self-centering to
Non self-centering
① . ⑤
To change the gimbal sticks self-centering or non self-
centering.
② . ⑥
To change vertical tension strength of
the gimbal sticks.
③ . ⑦
To change horizental tension strength of the gimbal
sticks.
④ . ⑧
To change the vertical friction strength
of the gimbal sticks.
1. Use a Phillips screwdriver to adjust the screw ① counterclockwise until the gimbal reaches its
center point.
2. Adjust screw ④ counterclockwise to adjust the frictional strength.
3. If you need to adjust the strength of the return, adjust screw ② to change the strength of return to
the median position, and to strengthen the strength clockwise, otherwise it's to reduce.
1. Use a Phillips screwdriver to adjust the screw ① clockwise so that the gimbal is no longer at its
center point.
2. Adjust the screw ④ clockwise to strengthen or reduce the frictional strength.
3. If you need to adjust the strength of the return, adjust screw ② to to change the strength of return
to the median position, and to strengthen the strength clockwise, otherwise it's to reduce.
3.2.5 Power Switches
To prevent false triggering, there are two switches on the lower part of the transmitter. Turn on or turn off the
transmitter when both switches are pressed at the same time.
3.2.6 Charging Modes
PL18 EV can be charged in two ways:
1. Plug the micro USB cable into the charging port for charging.
2. Use the wireless charging dock to charge it (as shown in the figure)
Notes：
1. Charge it within the safe range [4h@5V*2A/7h@5V*2A (wireless charging)].
Overcharging may lead to battery damage;
2. To prolong the service life of the battery, properly discharge if you want to
store it for a long time (that is, not fully charged). In addition, you need to
charge it regularly to prevent damage due to not-operation for long term,
and charge it regularly to prevent over-discharging damage during storage;
It is recommended that the lithium battery be charged to 40-50% of its
capacity for preservation. For example, it is recommended that the storage
voltage of lithium battery is3.85V in case of preservation. You need to check
the voltage valueof the battery every 3~6 months. If it is lower than 3.85V,
please recharge it until the battery reaches the said voltage value before
represervation. Please use the standard charging cable of this transmitter.
Improper use may cause damage to the battery and affect its service life.
ATTENTION
• Please use the standard charging cable
of this transmitter. Improper use may
cause damage to the battery and affect
its service life.
