ENGLISH - 4
Maintenance - Cleaning the Air Filter
WARNING
Do not oil the filters
1. Follow the procedure described in '
Caring for
your Lawnmower
•
DO NOT REMOVE the cap (Q2) or screws
(Q3) unless there is visual evidence of grass
or dirt.
2. Remove the two screws
(Q4)
. Take off the filter
cover.
(Q1)
3. Remove the two filters
(Q5)
and
(Q6)
. Clean
inside the filter cover
(Q1)
thoroughly.
4. Shake or tap the thick filter
(Q5)
to remove any
dirt or dust.
5. Replace the thin filter
(Q6)
if it is contaminated
with dust. New filters are available from your
local
Electrolux Outdoor Products Service
Centre/Dealer
.
6. Install the thick filter
(Q5)
in the filter cover
(Q1)
.
Place the thin filter
(Q6)
on top.
DO NOT
CREASE THE FILTERS
.
7. Clean the filter body
(Q7)
with a small brush.
Replace the filter cover
(Q1)
and the two screws
(Q4)
.
Caring for your Lawnmower
If you do not intend to use your lawnmower for
long periods it is advisable to follow this
procedure after use:
1. Stop the engine.
2. Close the fuel tank air vent screw and fully close
the fuel tap.
(J1)
3. Restart the engine.
4. As fuel runs out the engine will begin to stop, tilt
the lawnmower.
(L)
5. Once the engine has stopped, release the
Operator Presence Control.
6. Disconnect the spark plug lead.
7. Remove all fuel from the fuel tank.
Cleaning
•
Keep your lawnmower clean
-
grass clippings
left in any of the air intakes, around the
engine or under the deck could become a
potential fire hazard.
•
Do not clean with chemicals, including petrol, or
solvents - some can destroy critical plastic
parts.
1. Remove grass from under the deck with a piece
of wood or similar.
2. Using a soft brush - remove grass clippings from
around the engine and from all air intakes.
3. Remove the fan,
See 'Removing and Fitting
the Blade and Fan',
and clean with a soft
brush.
4. Wipe over the surface of your lawnmower with a
dry cloth.
Carrying your Lawnmower
•
Never carry a lawnmower when it is running
Carry the lawnmower at the point of balance with
the blade facing away from you and the air
cleaner facing upwards.
(P)
Storing Your Lawnmower
Store in a cool, dry, damp-proof and safe place. Service
your lawnmower after the last cut of the year as follows:-
At the end of the Mowing Season
1. Stop the engine.
2. Close the fuel tank air vent screw and fully close
the fuel tap.
(J1)
3. Restart the engine.
4. As fuel runs out the engine will begin to stop, tilt
the lawnmower.
(L)
5. Once the engine has stopped, release the
Operator Presence Control.
6.
Disconnect the spark plug lead.
7. Remove all fuel from the fuel tank.
8. Remove the spark plug lead and spark plug. Pour
one teaspoon (5ml) of oil through the spark plug
hole. Pull the starting handle 2 or 3 times. This will
distribute oil on the internal surfaces of the engine.
Inspect, clean and replace the spark plug. If a new
spark plug is required contact your local approved
Electrolux Outdoor Products Service Centre/Dealer.
Do not re-connect the spark plug lead.
9. Clean the air filter. See
'Cleaning the Air
Filter'.
10. Renew the blade if it is cracked, damaged or
bent. Renew the blade bolt if necessary.
See
'Removing and Fitting the Blade and Fan' for
complete instructions.
11. Use only genuine Flymo parts and accessories
specified for this product.
12. Clean your lawnmower thoroughly
See 'Cleaning'.
13. Your local approved
Electrolux Outdoor
Products Service Centre/Dealer
will carry out
any service or repairs required.
14. Store your lawnmower in a cool, dry, damp-proof
and safe place.