Page 29
Flymaster GPS M User Manual v. 1.0
Dist.Toff
Distance to take off is the distance between the current point and the flight starting point.
Dur.
Flight Duration. Duration of the current flight.
Flight Level
Current altitude in hundreds of feet, based on a fixed QNH of 1013.25hPa.
Floor
Shows the lower altitude of the airspace causing the warning, i.e. airspace that you are violating
or close to violating.
G-Force
Current G-Force being experienced by the pilot when using the Heart-G sensor.
G.R.Next
Glide Ratio to Next. Necessary glide ratio to reach the next turn point.
G.R.Toff
Glide ratio to takeoff. Necessary glide ratio to reach the take off.
GPS Alti
Altitude reported by the GPS.
Ground
Height of the ground at current location.
Heading
Heading in degrees returned by GPS.
Latitude
Current position latitude according to the format defined in the settings menu.
Longitude
Current position longitude according to the format defined in the settings menu.
Max. Altitude
Maximum altitude reached during current flight. This is based on barometric altitude.
Max. Climb
Once a flight has started, it shows the maximum rate of climb encountered during the flight. This
value uses the instantaneous rate of climb. This value is reset when the instrument is switched
off.
Max. Sink
Once a flight has started, it shows the maximum r sink encountered during the flight. This value
uses the instantaneous vario.
This value is reset when the instrument is switched off.
Max.G
Max Gforce reached during flight
Max.Speed
Maximum Speed (returned by GPS) reached during the flight. When the instrument is switched
off this value is reset back to zero.
Min. Altitude
Minimum altitude reached during current flight. This is based on barometric altitude.
Odometer
Distance travelled in the current flight
Speed
Indicates ground speed. The speed is only available when the GPS receiver has a valid signal.
Thermal top
The highest point reached during the current thermal.
Thrml.Perfo.
Perfomance of the most recent thermal showing average rate of climb in most recent thermal.
Time
Current local Time. This value is automatic revised when the device gets a valid Gps Signal.
(see Note 2)
Trans.G.R.
Glide ratio during transition. Average glide ratio during transitions between thermals.
TTD
Time to destination
Turnpoint size
Radius of the active turnpoint.
Vario
Instant vario value.
