SkyRanger Nynja 600 Operators Manual issue 1
25
7.
Rigging and De-rigging
7.1 To attach the wings to the Nynja:
With the wing tip raised to approximately the rigged height, slide
the wing root into place to engage in the root brackets.
Insert the wing root fixing bolts.
Attach the lift struts and jury struts
Tighten all attachment bolts and insert safety rings
Connect flap pushrod
Connect Pitot line
Connect aileron cables
Ensure aileron cables are crossed as per placard in cockpit on
central upright.
Final inspection of all nuts and bolts, cable routing and
attachments
Note that whist fitting the wing it must be held up at the tip until the wing
root fittings and lift struts are attached. Lowering the wing tip during this
process can damage the structure.
Although it may be possible to devise supports to enable one person rigging /
derigging, a minimum of two people are normally required.
7.2 To remove the wings from the Nynja:
Disconnect aileron cables
Disconnect pitot line
Disconnect flap pushrods
Remove safety rings from lift strut bolts (if fitted)
Remove nuts from lift strut bolts and spar bolts
Support wing tip
Remove lift struts
Remove spar bolts (wing root)
Slide wing outwards until spar is clear of cabin.
Summary of Contents for SkyRanger Nynja 600
