Rack Mount Kit
Installing a Dual Rack Mount Kit
3
Installing a Dual Rack Mount Kit
To install the Y8846D Rack Mount Kit, first follow
the steps 2, 3, and 4 listed under “Installing a Single
Rack Mount Kit” earlier in this document. Next,
perform the following steps to install the second
Meter:
1.
Insert a second #6-32 x ½" flathead screw through
the hole in the back of the tray into the back of the
second Meter.
2.
With the tray flat on a desk with the rack screw
ears toward you, place the second Meter so the
right side of the front frame is against the right
wall of the tray.
3.
Insert the Dual Center Mount between the two
Meters, keeping the holes on the bottom.
4.
Insert two #6-32 x ¼" screws through the bottom
of the tray and into the Dual Center Mount.
5.
Install the assembled rack mount kit into a rack
using the two 1" wide small filler plates and four
#10-32 x ¾" Phillips rack screws.
6.
Complete the installation by installing the Meter’s
power cord and other IO accessories through the
rear of the rack.
2x Small filler plate
4x #10-32 x 3/4”
rack screw
2x #6-32 x 1/2” Panhead
2x #6-32 x 1/4” Flathead
2x #8-32 x 1/2” Panhead
Dual center
mount
Dual Rack Mount
1
2
3
5
4
caw503f.emf
Figure 3. Dual Rack Mount
