Fluke Versiv, User Manual

Page: 150 / 260

Versiv Cabling Certification Product Family
Users Manual
136
Step 1: Set the Reference in Far End Source Mode
1-1
Turn on the tester and source let them sit for a minimum of
5 minutes. Let them sit longer if they are above or below
ambient temperature, or if the instructions for the source
specify a longer time.
1-2
Make sure that the home screen shows the correct settings for
the job, and the test type is
Far End Source
.
To make sure that other settings are correct, tap the test
setup panel, make sure the correct test is selected on the
CHANGE TEST
screen, then tap
EDIT
to see more settings.
Table 6 on page 111 describes the settings.
1-3
Clean and inspect the connectors on the tester, source, and test
reference cords.
1-4
On the home screen tap
SET REF
.
1-5
In the
TEST MODE
window, select
Auto CertiFiber Pro
or the
type of source you will use, then tap
DONE
.
1-6
On the
SET REFERENCE
screen, tap
RUN WIZARD
.
Notes
To only set the reference, and not measure the
loss of your test reference cord, tap SKIP WIZARD
on the SET REFERENCE screen.
Fluke Networks recommends that you measure
the loss of your test reference cord each time you
set the reference.
1-7
Make the connections to set the reference as shown on the
screen, then tap
NEXT
to see the completed connections.
Figure 53 also shows the completed connections.
Note
The SET REFERENCE screen shows reference
connections for the selected reference method.
Figure 53 shows connections for the 1 Jumper
reference.