7
Operation
Operation
TS22 Amplified Speaker Mode
To put the TS22 Test Set into amplified speaker mode:
1
Connect the test set to a line. The TALK/MONITOR
switch may be in either position.
2
Press the SPEAKER button once to enter amplified
speaker mode with low volume.
3
Press the SPEAKER button a second and third time
for medium and high volume.
4
Press the SPEAKER button a fourth time to turn
the amplified speaker off.
Pressing the MUTE button while in amplified speaker
mode turns the speaker off.
TS22A Speakerphone Mode
To put the TS22A Test Set into speakerphone mode:
1
Connect the test set to a line. Set the TALK/
MONITOR switch to T.
2
Press the SPEAKER button once to enter
speakerphone mode with low volume.
3
Press the SPEAKER button a second and third time
for medium and high volume.
4
Press the SPEAKER button a fourth time to turn
the speakerphone off and return to Talk mode.
Pressing the MUTE button while in speakerphone
mode mutes the speakerphone microphone for
privacy.
TS22A Speaker Monitor Mode
To put the TS22A Test Set into speaker monitor mode:
1
Set the TALK/MONITOR switch to M, then press
the SPEAKER button once to enter speaker mode
with low volume.
2
Press the SPEAKER button a second and third time
for medium and high volume.
3
Press the SPEAKER button a fourth time for off
and return to Monitor mode.
Selecting a Dial Signal
Select the type of dial signaling required, DTMF or dial
pulse, with the TONE/PULSE switch:
1
Set the TALK/MONITOR switch to M.
2
Connect test set to the line; listen to verify that the
line is idle.
3
Set the TALK/MONITOR switch to T, and verify that
dial tone is received.
4
Enter the number to be called. If DTMF signaling
has been selected, the tones associated with each
digit are generated as each key is pressed. If rotary
dial pulse signaling has been selected, the number
may be entered at any rate on the keypad; digits
will automatically be pulsed out at the correct
rate.
To terminate the call, either during or after dialing,
return the TALK/MONITOR switch to the M position.
Last Number Redial
Note
When dialing out through a PBX, you may use
the PSE key to insert a pause before initially
dialing the number. See “Putting a Pause in a
Stored Number”.
In the Tone or Pulse mode, the last number dialed can
be automatically redialed by pressing the LNR key after
going on-hook and then back off-hook.
