Fluke TS 1200, User Manual

Page: 31 / 44

3-3
Charging the Batteries
Charging the Batteries
The TS1200 Test Set is designed to operate on either four NiMH batteries or four AA alkaline
batteries. An AC adapter (12 VDC ±10%, 600 mA) or a car adapter may be used to charge the
NiMH batteries.
If NiMH batteries are installed, charging begins when the AC or car adapter is connected. Do not
use the Test Set while the batteries are charging. The charger cannot supply enough power
under certain modes of operation.
The NiMH batteries should be cycled (fully charged, then fully discharged) two or three times
before first use. When fully charged, the NiMH batteries can power the test set for 8 to 10 hours
of standard operation. A single charge should last the user an entire day assuming the test set is
turned off much of the time.
To prolong battery life, connect the adapter/charger while the test set is not in use. If the test set
will not be used for at least 1 day, remove the batteries or connect the charger.
To charge the NiMH batteries:
1 Connect the AC adapter/charger to the TS1200 Test Set; then plug the AC adapter/charger
into a 120 VAC wall plug (ordinary household current).
While the test set is charging, the Home screen displays this message: Charging. To use
TS1200 unplug the charger
.
Note
When the adapter/charger is plugged in, the test set cannot be used.
2 When the batteries are full, the F icon appears on the screen next to the charger plug icon.
Replacing the Batteries
Use one of the following types of batteries:
•
4 NiMH rechargeable batteries supplied with the TS1200 Test Set
•
4 AA alkaline batteries
To replace the batteries:
1 Turn the test set off and disconnect the AC adapter/charger from the test set, if attached.
2 Place the test set on a protected work surface, face down.
-continued-