Fluke TS 1200, User Manual

Page: 21 / 44

2-13
Configuring Your Test Set
Configuring Your Test Set
Note
Pressing the Home key at any screen will return you to the Home screen.
Your test set can be configured by selecting either 3 - POTS CONFIG, 4 - ADSL CONFIG, or
5 - System CONFIG
on the Home Screen (the first screen displayed upon powering up the unit).
POTS Configuration
The following options can be accessed from the POTS Configuration screen.
Pause Duration Different systems may require different pause durations to allow enough time
for the second dial tone to be returned. On the TS1200 the pause duration can
be programmed. The default pause duration is 4 seconds.
To change PBX Pause duration:
1 Press 1 - Pause Duration.
2 Use the number keys to select the desired pause length.
3 Press F1 - Accept.
Flash Duration The hook flash duration default value is 600 ms. To change the flash duration
value:
1 Press 2 - Flash Duration.
2 Use the number keys to select the desired hook flash length.
3 Press F1 - Accept.
Speaker Timeout The loud speaker is one of the largest sources of battery drain in the test set.
The battery will be drained quickly if the loud speaker is left on continuously.
To extend battery life, the test set has a timeout function that automatically
turns off the loud speaker after the timeout period. A timer is started
whenever the test set’s speaker is turned on. The timer operates in both
Monitor and Talk modes.
The speaker default timeout duration is 1 minute. Remember, the longer the
selected timeout duration the shorter the battery life. To change the speaker
timeout duration:
1 Press 3 - Speaker Timeout.
2 Use the number keys to select the desired duration.
3 Press F1 - Accept.
-continued-