Ti32, TiR32, Ti29, TiR29, Ti27, TiR27
Users Manual
4
•
User Manual (in various languages)
•
SmartView
®
Software
•
Warranty Registration Card
Note
Fluke recommends the use of the supplied SD memory card with the
Imager. Fluke does not warrant the use or reliability of aftermarket
SD memory cards of different brands or capacities.
See Table 2 for a list of accessories that are available for the Imager.
Table 2. Accessories
Model Description
PN
FLK-TI-LENS/WIDE1 Wide Angle Infrared Lens
3441183
FLK-TI-LENS/TELE1 Telephoto Infrared Lens
3441176
FLK-TI-SBP3 Smart
Battery
Pack
3440365
FLK-TI-SBC3
Charging Base/Power Supply with
Adapters
3440352
TI-CAR CHARGER
12 V Vehicle Charger Adapter
3039779
Charging the Battery
Before using the Imager for the first time, charge the batteries in the included
two-bay charging base for at least two and one-half hours. The charging status
of each battery will be shown on the five-segment battery charge indicator on
each battery.
Note
New batteries are not fully charged. Two to ten normal
charging/discharging cycles may be required before the battery
charges to its maximum capacity.
To charge the Imager’s battery, select one of the options that follow:
Two-Bay Charging Base
1.
Plug the ac power supply into an ac wall outlet and connect dc output
to charging base.
2.
Insert one or two smart batteries into bays of charging base.
3.
Charge batteries until charge indicators show “full”.
Shop for Fluke products online at:
1.877.766.5412
www.
MyFlukeStore
.com
