Fluke PG9000 Series, Operation And Maintenance Manual

Page: 18 / 202

PG9602™ OPERATION AND MAINTENANCE MANUAL
© 2011 Fluke Calibration Page
8
1.3.2 Remote Electronics Module (REM) Rear Panel
The PG9000 Remote Electronics Module houses all working electronics (processor, sensor
and communications) for the PG9000 in addition to sensors for ambient conditions
(temperature, pressure and humidity).

COM 2 (RS232) – External
Barometer, External Vacuum
Gauge and Pass through
Communication

COM 3 (RS232) – Automated
Pressure Generation/Control
Component

PG DRIVER – 15 pin Cable to
PG Base

ATM Connection (Barometer)

Mounting Post PRT Connector to
PG Remote Electronics Module

TH Probe Connector

COM 4 (RS232) – Pass Through

COM 1 (RS232) – Remote Host
Communications

IEEE-488 – Remote Host
Communications

AMH Connection

Connector for 25 pin Cable to PG
TERMINAL
Figure 3. PG9000 Remote Electronics Module Rear Panel
1.3.3 Base Rear Panel
The PG9000 Platform rear panel provides the communications connection to the PG Remote
Electronics Module, Test port connection, a vacuum vent port connection, and connections for
the option Automated Mass Handler.

PG Driver – to PG Remote
Electronics Module

AMH Connection

AMH Vent Port

TEST Pressure Port

AMH Drive Pressure Port

PRT Connector – to Remote
Electronics Module
Figure 4. PG9602 Base Rear Panel