Fluke PG9000 Series, Operation And Maintenance Manual

Page: 165 / 202

Page 155 © 1998-2010 Fluke Calibration
5. Maintenance, Adjustments And
Calibration
5.1 Introduction
PG9000 was designed for very low maintenance operation. Standard preventative maintenance includes:
•
Adjustment of piston position measurement system (see Section 5.2.2)
•
Cleaning piston-cylinders (see Sections 5.3.3).
•
Lubricating piston-cylinder modules (see Section 5.3.4)
•
Cleaning masses (see Section 5.4.1)
•
Adjustment/calibration of on-board ambient conditions sensors (see Sections 5.2.1.2 - 5.2.1.4 )
•
Calibration of piston-cylinder temperature platinum resistance thermometer(s) (PRT) (see Section
5.2.1.5)
•
Calibration of reference vacuum sensor (see Section 5.2.1.6)
•
Calibration of piston-cylinder modules and mass set (see Sections 5.3.5, 5.4.2)
•
Drive belt replacement (see Section 5.2.3)
This section provides information on maintenance, adjustment and calibration procedures and certain
repair procedures.
Note
Calibration, maintenance and repair services for PG9000 are offered by authorized
Fluke Calibration Authorized Service Providers (see Table 28).

Caution
•
PG9000 is a sophisticated measuring instrument with advanced on-board
features and functions. Before assuming that unexpected behavior is
caused by a system defect or breakdown, use this manual and other
training facilities to become thoroughly familiar with PG9000 operation.
For rapid assistance in specific situations, see Section 6, Troubleshooting.
•
PG9000 is covered by a limited 1 year warranty (see Section 7.4).
Unauthorized service or repair during the warranty period is undertaken at
the owner's risk and may cause damage that is NOT covered under product
warranty and/or may void the product warranty.

Warning
•
Use only specified replacement fuses (see Section 1.2.1).
•
PG9000 should only be repaired by an approved technician.