Fluke Pan Tilt System, User Manual, Page: 36 / 63

Pan Tilt System
Users Manual, Rev. 1.0, May 2020
36
Figure 5-2: Cable Lead Through Wall Mount Bracket (left) and Wall Mount Bracket (right)
Open the hatch by undoing the screws as shown in the figure below. Insert the cables into the cable glands
holding the base at about 20 cm (7.9 in) from the support.
Figure 5-3: Hatch Opening
Use the power cable and the Ethernet network cable provided by the manufacturer. The Ethernet cable is already
fitted with a connector, so it is necessary to use the special seal provided.
Tightening torque: 2.7 Nm (23.9 lbf in)
Figure 5-4: Ethernet Cable Gland
Once you have positioned the gasket (01), fix the base (02) onto the bracket (03) with screws (04), serrated
washers (05) and screw rings (06). Use the screws and washers provided with the support.
Tightening torque: 6 Nm (53.1 lbf in)
50 cm
(19.7 in)
50 cm
(19.7 in)
Power Supply Ethernet