Fluke db PRUFTECHNIK SHAFTALIGN touch, Manual

Page: 106 / 127

Vertical results
l
(1) Flange correction in 0-6 direction
l
(2) Flange correction in 3-9 direction
l
(3) Bolt position
l
(4) Shimming values
l
(5) Coupling gap and offset in the 0-6 direction
l
(6) Coupling gap and offset in the 3-9 direction
l
(7) Shim correction modes
l
(8) Shim correction mode used in this example
l
(9) Initiates Live Move
l
(10) Tapping the coupling results area accesses the measurement table.
In the results screen, the three icons – dimensions, measurement and results –
are active and may be used anytime.
Shimming modes
Shimming modes are defined as follows:
l
(1) mode indicates all positive shimming
l
(2) mode indicates "zero/plus" shimming. In this mode, one bolt position is set to zero
and the rest are positive
l
(3) mode indicates optimized shimming. In this mode, half of the corrections will pos-
itive, and the other half negative.
l
(4) mode indicates "zero/minus" shimming. In this mode, one bolt position is set to zero
and the rest are negative.
l
(5) mode indicates all negative shimming
Sign convention
POSITIVE GAP opens towards 0:00 or 3:00
POSITIVE OFFSET if the top coupling half is offset towards 0:00 or 3:00
SHAFTALIGN touch 105
On-board help