Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 63 / 700

Chapter 1: Get Acquainted
The HOME Screen
27

Enter an ID, select a different ID in the ID set, select a
different set of IDs, or make a new set. The tester adds the
IDs and ID sets you make to the project that shows on the
home screen.

Turn
Auto Save
on or off.
 Select
End 1
or
End 2
for OTDR and FiberInspector tests
and loss/length tests in Far End Source mode.
 Enter a name for
End 1
and
End 2
.

Operator
: The name of the person who does the job. You can
enter a maximum of 20 operator names.
For each operator you can also enter the email address that the
operator will use as an ID to sign in to LinkWare Live.
To change the email address associated with an operator, select
the operator, then sign in to LinkWare Live with a different
address on the
LWL SIGN IN
screen. See Chapter 18.

TOOLS
: The
TOOLS
menu lets you set up the compensation
function for the launch/tail cords, use tools such as the real-time
trace and the FiberInspector test, see the status of the tester, and
set user preferences such as the language and the display
brightness.

RESULTS
: Tap
RESULTS
to see and manage the results that are
saved in the tester.

SYNC
: To upload test results to LinkWare Live, tap
SYNC
. See
Chapter 18.

TEST
: Tap
TEST
to do the test shown in the test setup panel.
 The percentage of the tests in the project that are completed.
The tester uses the number of available IDs and, for fiber tests,
the tests you selected on the
CABLE ID SETUP
screen to calculate
this percentage. See Figure 198 on page 526.
% Tested
does not
show if your project contains only a
Next ID
list. See “To Make ID