Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 307 / 700

Chapter 9: Certify Fiber Cabling
Autotest in Smart Remote Mode
271
GPU161.EPS
Figure 114. CHANGE ID Screen for Smart Remote Mode

Input Fiber ID
and
Output Fiber ID
show the IDs for the fibers
connected to the testers INPUT and OUTPUT ports at the end of
the test. The
Input Fiber ID
follows the last
Output Fiber ID
you
used. To see the input or output fiber IDs that have not been
tested or to change the input ID, tap the
Input Fiber ID
window.

To select or edit an ID set or to make a new ID set, tap
CHANGE
CABLE IDs
.
 To swap the input and output fiber IDs, tap . The tester uses
subsequent IDs from the list or sequence in descending order.
A
B
C