Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 241 / 700

Chapter 6: Diagnose Copper Test Failures
How to Use the Measurement Cursor on the HDTDR and HDTDX Plot
205
GPU113.EPS
Figure 90. How to Use the Measurement Cursor on the
HDTDR or HDTDX Plot

To specify the start of a measurement, tap the yellow circle
(
 ), then tap
MARK
.

To see the
MARK
and
UNMARK
buttons, tap the yellow circle.
When
MARK
or
UNMARK
shows, you can drag the cursor.

To move the cursor in small increments, tap or press and hold
or . If these buttons do not show, tap the yellow circle on the
cursor.
 The measurement in the box is the distance from the start of the
cabling to the cursor.
 The measured value of crosstalk or return loss at the cursor’s
location.
 The distance between the start and end of the green
measurement bar.
A
D
E
C
G
C
B
F
H