Fluke CableAnalyzer DSX-5000, Technical Reference Handbook, Page: 195 / 700

159
Chapter 4: Test Twisted Pair Through
a PoE Device (DSX-5000)
The AC wire map test lets you see the wire maps of links
connected through midspan PoE (Power over Ethernet) devices.
Midspan PoE devices block the DC signals the tester uses to do the
wire map test. When you turn on the AC wire map test, the tester
uses AC signals instead of DC signals for the wire map test. This
setting does not change how the tester does other tests.
Note
The DSX-8000 modules do not support the AC wire map test.
How to Turn On the AC Wire Map Test
Note
The AC Wire Map test is not available when a DSX-
8000 module is installed.
1
On the home screen, tap the test setup panel.
2
On the
CHANGE TEST
screen, select a twisted pair test to
change, then tap
EDIT
.
3
On the
TEST SETUP
screen, tap the
AC Wire Map
control to set
it to
On
.
4
Tap
SAVE
.
When the
AC Wire Map
test is on, this icon shows on the home
screen: