Fluke CableAnalyzer DSP-4100, User Manual

Page: 73 / 216

Autotest
Automatic Diagnostics
3
3-7
Automatic Diagnostics
If an Autotest fails, you can press
F
to see more specific information on the
cause of the failure. Figure 3-4 shows examples of automatic diagnostics displays
for a NEXT failure and an open pin failure.
The arrow in the diagram at the top of the display shows the location of the failure.
The bottom half of the display describes the failure and suggests ways to fix the
fault. When appropriate, softkeys let you see the plot or plots relevant to the
failure. If more than one fault was found, you can use the
$ Next Fault
and
# Prev Fault
softkeys to scroll through the diagnostics displays.
See Chapter 4 for information on the HDTDR

and HDTDX

plots.
oy09c.bmp
Figure 3-4. Examples of Automatic Diagnostics Displays