Fluke CableAnalyzer DSP-4100, User Manual

Page: 56 / 216

DSP-4000 Series
Users Manual
2-36
Editing the Report Identification
The report identification includes a custom header (your company name, for
example), an operator name, and a site name. These items appear on saved
Autotest reports. You can view and edit this information as follows:
1. Turn the rotary switch to SETUP.
2. Use
D
to highlight
Edit
under
Report Identification
; then
press
E
. The REPORT IDENTIFICATION display shows the information
that will appear on the Autotest reports you save.
3. Use
D U
to highlight the information you want to edit; then press
E
.
If you are editing an operator or site name, you can press
@ New
to add a
new name. The
New
softkey appears only if less than 20 names have been
entered. If 20 names have been entered, you must delete a name before adding
a new name.
To rename or delete an existing operator or site name, press
! Edit
,
select the desired name; then press
! Rename
or
@ Delete
.
Changes to names preceded by a "$" appear on printed test reports. You
cannot delete a name that is used on a saved report.
4. To add characters to the name, use the
L R
and
D U
keys to highlight
characters in the list, then press
E
.
To delete the character left of the cursor, press
$ Delete
.
To edit characters in the middle of a name, use
! Å
to move the cursor into
the name.
To move the cursor back to the right-most character, press
! Å
until the
cursor wraps back to the right.
To increment or decrement an alphanumeric character anywhere in the cable
identification, use
! Å
to highlight the desired character; then
press
@ INC
or
# DEC
.
5. To store the name, press
S
.
Note
You can use LinkWare software to download report identification
information from a PC to the test tool.