Fluke 9640A Series, Instruction Manual

Page: 88 / 324

9640A
Instruction Manual
3-40
Defining the Leveled-Sine Output Signal
Use the following procedure to create a leveled-sine output signal and, if required, to
define the incremental step values by which the frequency and level of the output signal
can be increased or decreased. As you perform the procedure, refer to Table 3-14 for a
list of the fields available on the
Leveled-Sine
screen and the limits associated with each
field.
Use the following procedure to define the leveled-sine output signal:
1.
Press

to open the
Leveled-Sine
screen.
2. Select the
Frequency
field (
Cursor edit
enabled) and enter the desired output
frequency.
3. If required, press the
Frequency
soft key again to enable
Step edit
.
a. Select the
Freq Step (Step Size)
field.
b. Enter the desired frequency step in the field.
4. Select the
Level
field (
Cursor edit
enabled) and enter the desired output level.
5. If required, press the
Level
soft key again to enable
Step edit
. A
Level Step
field
appears at the bottom of the screen.
a.
Select the
Level Step
field.
b. Enter the desired level step in the
Level Step
field.
6. To make the leveled-sine wave available as an RF Output signal, press

.
7. To step the output frequency, select the
Frequency
field (
Step edit
enabled) and use
the cursor keys to increase or decrease the output frequency by the amount specified
in the
Freq Step
field.
8. To step the output level, select the
Level
field (
Step edit
enabled) and use the cursor
keys to increase or decrease the output level by the amount specified in the
Level
Step
field.