9132A Service
3-6
NOTE
To
prevent confusion after
the
back
of
the Pod
is
closed,
each
of
the ROM Modules should be numbered as you
insert
them into
the
ROM
Module connectors.
Stick
one
of
the numbered labels {provided with the Pod) on the
back
of
the UUT connector plug.
2.
After plugging
in
the ROM Module(s) (and the Sync Module), secure
the cables
by
tightening the cable
tie
located on the back panel of the
Pod.
Installing
the
RAM
Module(s)
3-13.
For each ROM Module that has been installed
in
the Pod,
an
equivalent
number of RAM Modules must also
be
installed. (For convenience, the Pod
operates correctly if more RAM Modules than ROM Modules are installed.)
Plug the RAM Module(s) into the connectors
on
the right side of the main
pea
(as
shown in Figure
3-4).
If only one ROM Module has been installed,
install one RAM Module in the “RAM
1”
connector. If two ROM Modules
have been installed, install RAM Modules into the “RAM
1”
and “RAM 2”
connectors. If four ROM Modules have been installed, install RAM Modules
in
all
the RAM connectors.
RAM
MODULE
SOCKETS
RAM
RAD
RAMS
BANS
REAR PANEL
Figure 3-4.
Connecting the
RAM
Modules
Summary of Contents for 9132A
