Calibration Furnace
Operation
33
Set the Furnace Temperature Manually
To adjust the furnace temperature manually:
1. Push
.
2. Push
.
3. Push
to increase the temperature or push
to
decrease the setpoint temperature.
Note
When you push the up or down key momentarily,
the setpoint temperature moves by one step. Push
and hold the key and the setpoint temperature
increases or decreases until the key is released.
4. Push
to save the setpoint temperature and start
the furnace.
Note
After a maximum of 5 seconds, the furnace starts
to heat or cool to the setpoint temperature.
The actual temperature is the measured temperature in
the furnace and lags the setpoint temperature. The lag
interval is the time necessary to increase or decrease the
temperature of the center of the furnace.
How to Stop the Furnace Heat Cycle
To stop the furnace heat cycle:
1. With the main screen in the display, push
.
2. Push the softkey below
SAVE/DISABLE
.
The heat or cool procedure stops and the Product is set to
standby mode.
Change a Preset Temperature
You can set the temperature of the eight presets. To
change a preset temperature:
1. Push
.
2. Push the softkey below
SELECT PRESET
.
3. Push
or
to scroll to the preset to change.
4. Push the softkey below
EDIT PRESET
. As shown in
Figure 22 the temperature of the selected preset is
highlighted in the display.
gxs112.eps
Figure 22. Change Preset Temperature
